一 在Linux下执行route命令
[root@localhost backup]# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.0.1 0.0.0.0 UG 100 0 0 enp0s3
192.168.0.0 0.0.0.0 255.255.255.0 U 100 0 0 enp0s3
192.168.122.0 0.0.0.0 255.255.255.0 U 0 0 0 virbr0
[root@localhost backup]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
default gateway 0.0.0.0 UG 100 0 0 enp0s3
192.168.0.0 0.0.0.0 255.255.255.0 U 100 0 0 enp0s3
192.168.122.0 0.0.0.0 255.255.255.0 U 0 0 0 virbr0
二 route命令详解
1、命令语法
route [-n]
选项与参数:
-n:将主机名以IP方式显示
2、查询结果分析
Destination :其实就是Network的意思。
Gateway :就是该接口的
Gateway的IP,若为0.0.0.0,表示不需要额外的IP。
Genmask :就是Netmask,与
Destination组合成一台主机或网络。
Flags :共有多个标志可以来表示该网络或主机代表的意义。
U:代表该路由可用。
G:代表需要经过
Gateway来帮忙传递。
H:代表该行路由为一台主机,而非一个网络。
Iface :就是interface(接口)的意思。