版权声明:博主的博客不值钱随便转载但要注明出处 https://blog.csdn.net/easylovecsdn/article/details/81812453
需要注意的是,使用了库函数的模板就不能胡乱套用寄存器的操作,之前还想放个大招结果出丑了,这里的实验要求是绿灯亮,蜂鸣器响,红灯亮,蜂鸣器停止,蜂鸣器响起间隔半秒,led的文件我这里就不给出了,主要放出beep的文件吧,这里操作的是PF8口。
1.beep.h
#ifndef __BEEP_H
#define __BEEP_H
#include "sys.h"
#define BEEP PFout(8)
void beep_init(void);
#endif
2.beep.c
#include "beep.h"
void beep_init()
{
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_8 ;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_OUT;
GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;
GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;
RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOF, ENABLE);
GPIO_Init(GPIOF, &GPIO_InitStructure);
GPIO_SetBits(GPIOF, GPIO_Pin_8);
}
3.main.c
#include "stm32f4xx.h"
#include "usart.h"
#include "delay.h"
#include "led.h"
#include "beep.h"
int main(void)
{
uart_init(115200);
delay_init(84);
led_init();
beep_init();
while(1){
GPIO_ResetBits(GPIOF, GPIO_Pin_9);
GPIO_SetBits(GPIOF, GPIO_Pin_10);
GPIO_ResetBits(GPIOF, GPIO_Pin_8);
delay_ms(500);
GPIO_SetBits(GPIOF, GPIO_Pin_9);
GPIO_ResetBits(GPIOF, GPIO_Pin_10);
GPIO_SetBits(GPIOF, GPIO_Pin_8);
delay_ms(500);
}
}