1. 环境
2. 关闭FireWall和SELinux
2.1 FireWall
使用systemctl status firewalld查看防火墙的状态,如下(默认开启)
11月 13 14:40:51 localhost.localdomain systemd[1]: Starting firewalld - dyna...
11月 13 14:40:53 localhost.localdomain systemd[1]: Started firewalld - dynam...
Hint: Some lines were ellipsized, use -l to show in full.
如果你需要使用FireWall服务(正式环境下),则需要修改它的配置,因为在默认情况下,它会拦截大多数服务请求。具体可以参考配置firewalld服务的基本操作和设置。
如果由于某些原因(比如本文只是需要Linux服务器来搭建某些服务,不想控制防火墙只开放某些端口)等而不需要FireWall服务,则可以像下面那样停止并禁用它。
2.2 关闭SELinux
可以用getenforce 查看SELinux的状态,如下(默认开启)
//开启状态
Enforcing
同上,如果你想使用SELinux也可以。但是本人不想那么麻烦,所以把SELinux也关闭了。
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - No SELinux policy is loaded.
// 这里改变为disabled
SELINUX=disabled
# SELINUXTYPE= can take one of three two values:
# targeted - Targeted processes are protected,
# minimum - Modification of targeted policy. Only selected processes are protected.
# mls - Multi Level Security protection.
SELINUXTYPE=targeted
3. 一点错误
使用root权限用户操作