“.out Does not match the target endianness,not loaded. Check build ptions, or use the setup program. ”
出现上述错误,解决方案:
(1)首先检查硬件
检查“GP8/HD8”引脚的电位是否被拉低为“0”,如果拉低为0的话,是“big endianness”,如果为高电平为“little endianness”,dsp默认上电为“little endianness”。
(2)检查“program菜单下的build options中是否设置模式设为little endian”或者“big endianness”
(3)检查库文件是否添加正确
是库文件没添加对,小端模式的库是rts6713,csl6713.大端则为rts6713e,csl6713e.