5.一个VLAN=一个广播域=一个网段
VLAN是二层技术
7.静态VLAN命令:
1)创建VLAN:
conf t
vlan ID,ID,ID-ID
[name 自定义名称]
exit
2)查看VLAN表:
show vlan b
3)将端口加入到VLAN:
int f0/x
switchport access vlan ID
exit
二、trunk
1.trunk/中继链路/公共链路
作用:允许所有VLAN数据通过trunk链路
方法:通过在数据帧上加标签,来区分不同的vlan的数据
2.trunk标签:
1)ISL标签:cisco私有的,标签大小30字节26+4
2)802.1q标签:公有协议,所有厂家都支持,标签大小4字节。属于内部标签。
3.交换机端口链路类型:
1)接入端口:也称为access端口,一般用于连接pc,只能属于某1个vlan,也只能传输1个vlan的数据
2)中继端口:也称为trunk端口,一般用于连接其他交换机,属于公共端口,允许所有vlan的数据通过!
4.配置trunk命令:
int f0/x
[switchport trunk encapsulation dot1q/isl]
switchport mode trunk
exit
三.VTP配置
• 创建VTP域
Switch(config)# vtp domain domain_name
• 配置交换机的VTP模式
Switch(config)# vtp mode { server | client | transparent }
配置VTP版本
Switch(config)# vtp version 2
• 配置VTP版本
Switch(config)# vtp password 密码
• 查看VTP配置信息
Switch# show vtp status